Free guide and checker

ADA Bathroom Dimensions

An ADA bathroom is built so a person who uses a wheelchair can turn around, reach the fixtures and transfer to the toilet. The 2010 ADA Standards set exact numbers for each part. This page gives them in one place, with a drawing and a checker for your own measurements.

ADA bathroom dimension checker

Enter your measurements in inches. Each line shows if it meets the 2010 ADA Standards.

Lines that pass

10 of 10

Result

Meets ADA

  • Toilet centerline from side wall (16 to 18 in)Pass
  • Toilet seat height (17 to 19 in)Pass
  • Grab bar height (33 to 36 in)Pass
  • Rear grab bar length (36 in or more)Pass
  • Side grab bar length (42 in or more)Pass
  • Lavatory rim height (34 in or less)Pass
  • Knee clearance under lavatory (27 in or more)Pass
  • Door clear width (32 in or more)Pass
  • Toilet clear floor space (60 in wide x 56 in deep)Pass
  • Turning space (60 in circle) (room 60 x 60 in or more)Pass

A planning aid, not a code review. The turning line is simplified: the circle may not overlap the toilet. Your local code and the final plans rule.

ADA bathroom dimensions at a glance

The drawing shows a single-user toilet room to scale. The table lists the key numbers and the section of the 2010 ADA Standards for Accessible Design that sets each one.

17 inGrab bars: 36 in rear, 42 in sideClear floor space 60 x 56 in60 in turning circleToilet, 16-18 in to centerline
Section numbers are from the 2010 ADA Standards. Local codes can add to them.
ItemRequirementADA section
Turning space60 in circle, or a T-shape304.3
Clear floor space at a fixture30 x 48 in305.3
Toilet centerline16 to 18 in from the side wall604.2
Toilet clearance60 in wide x 56 in deep, measured from the side and rear walls604.3.1
Wheelchair stall depth56 in (wall-hung toilet) or 59 in (floor-mounted toilet), 60 in wide604.8.1.1
Toilet seat height17 to 19 in to the top of the seat604.4
Grab bar height33 to 36 in above the floor609.4
Lavatory rim34 in maximum606.3
Door clear width32 in minimum404.2.3

ADA toilet and grab bar dimensions

The toilet sits 16 to 18 inches from the side wall, measured to its centerline. This leaves room for a side grab bar on one side and open floor on the other, so a person can transfer from a wheelchair.

Two grab bars are needed. They are the most common mistake on plans, so check the lengths and where they start.

Grab barDimension
Side wall bar length42 in minimum
Side wall bar positionStarts no more than 12 in from the rear wall and reaches at least 54 in from it
Rear wall bar length36 in minimum
Rear wall bar positionAt least 12 in on one side of the toilet centerline and 24 in on the other
Height33 to 36 in above the floor, to the top of the gripping surface
Round bar diameter1 1/4 to 2 in
Space to the wall1 1/2 in
StrengthMust hold 250 lb
  • Flush control: on the open side of the toilet, no higher than 48 in.
  • Toilet paper holder: 7 to 9 in in front of the toilet and at least 15 in above the floor.
  • Seat: 17 to 19 in high, which is a comfort-height toilet.

ADA sink and lavatory dimensions

The top of the sink rim can be no higher than 34 inches. Under it, you need at least 27 inches of clear height for the knees and 9 inches of toe space, and a 30 by 48 inch clear floor space in front. Hot pipes and drains under the sink must be wrapped.

The bottom edge of a mirror over the sink can be no higher than 40 inches, unless it is a full-length mirror. For the vanity itself, see the guide to bathroom vanity height, which covers ADA vanity height in detail.

ADA shower and tub dimensions

Roll-in showers also need a clear floor space beside the opening.
Shower typeMinimum inside size
Transfer shower36 x 36 in
Standard roll-in shower30 x 60 in
Alternate roll-in shower36 x 60 in, with an opening on the long side
Seat height17 to 19 in
Controls48 in maximum above the floor
Hand-held spray hose59 in minimum long
Threshold1/2 in maximum

A bathtub needs a clear floor space alongside it, at least 30 inches wide and running the full length of the tub (60 inches for a standard tub), per section 607.2. Add a seat, grab bars and controls within reach of a person sitting on the seat.

What is the minimum ADA bathroom size?

The ADA does not name one room size. It sets clearances, and the room has to be big enough for all of them. In a single-user toilet room, that means the 60 by 56 inch clearance at the toilet, a 60 inch turning circle, a 32 inch door and a sink you can reach.

In practice, many designers plan about 5 by 8 feet or more for a toilet and sink. The door swing must not cross the toilet clearance. Use the checker above to test your own room before you draw it.

ADA bathroom rules for homes

The ADA covers public places and commercial buildings. A private house does not have to follow it. Homes fall under other rules, such as the Fair Housing Act for new multifamily housing and ANSI A117.1 for accessible units, plus state and local codes.

Many people still copy the ADA numbers in a home, since they are well tested. If you plan to age in place, they are a good target. The toilet-clearance guide on this site compares them with the home codes.

AI render of a bathroom with green tile

Picture your accessible bathroom first

Upload a photo or a plan of your bathroom and our AI renders it with new tile, fixtures and a wider layout, so you can see the result before you build.

Try AI interior visualization

Sign in with Google or email to render. New accounts get 1 free render (watermarked).

Frequently asked questions

What are the ADA bathroom dimensions?

A single-user ADA bathroom needs a 60 inch turning circle, a toilet centerline 16 to 18 inches from the side wall, a 60 by 56 inch clear floor space at the toilet, a 32 inch clear door, grab bars 33 to 36 inches high, and a sink no higher than 34 inches.

How far from the wall does an ADA toilet need to be?

The toilet centerline must be 16 to 18 inches from the side wall. The clear space on the other side must be at least 60 inches from the side wall in total.

How big is an ADA bathroom?

The ADA sets clearances, not one room size. The room must fit a 60 inch turning circle and the toilet clearance. Many designs are about 5 by 8 feet or larger.

How high are ADA grab bars?

Grab bars are mounted 33 to 36 inches above the floor. The side wall bar is at least 42 inches long and the rear wall bar at least 36 inches long. Each must hold 250 pounds.

How high is an ADA toilet?

The top of the toilet seat must be 17 to 19 inches above the floor. This is often sold as a comfort-height or right-height toilet.

Does the ADA apply to a bathroom in my house?

No. The ADA applies to public and commercial buildings. A private home follows local building code, and some housing falls under the Fair Housing Act or ANSI A117.1. You can still use the ADA numbers as a guide.

More free tools for architects and designers

Sources: 2010 ADA Standards for Accessible Design (U.S. Department of Justice), sections 304, 305, 306, 404, 604 (604.3.1 toilet clearance, 604.8.1.1 stall sizes), 606, 607 and 609, and the U.S. Access Board guide to the standards.